Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

TROUBLESHOOTING OPERATION NOTICE q The starting system for this machine uses 24V. For the normal machine, also use a 24V battery. q The size of the booster cable and clip should be suitable for the battry size. q The battery of the normal machine must be the same capacity as that of the engine to be started. q Check the cables and clips for damage or corrosion. q Make sure that the cables and clips are firmly connected. q Check that the work equipment lock levers and parking brake levers of both machine are in the LOCK position. q Check that each lever is in the NEUTRAL position.

CONNECTING THE BOOSTER CABLE Keep the starting switch of the normal machine and problem machine in the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Connect the clip of booster cable (A) to the positive (+) ter- minal of battery (C) on the problem machine. 2. Connect the clip at the other end of booster cable (A) to the positive (+) terminal of battery (D) on the normal machine. 3. Connect the clip of booster cable (B) to the negative (-) ter- minal of battery (D) on the normal machine. 4. Connect the clip at the other end of booster cable (B) to engine block (E) on the problem machine.

STARTING ENGINE Always check that the work equipment lock lever is set to the LOCK position, regardless of whether the machine is working normally or has failed. Check also that all the control levers are in the HOLD or NEU- TRAL position. 1. Make sure the clips are firmly connected to the battery terminals. 2. Start engine of the normal machine and run it at high idling speed. 3. Turn the starting switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, try again after 2 minutes or so. 3-140 WARNING