OPERATION TROUBLESHOOTING ENGINE 3 q ( ): Always contact your Komatsu distributor when dealing with these items. q In cases of problem or causes which are not listed below, contact your Komatsu distributor for repairs.
3-145 Problem Main causes Remedy Engine oil pressure caution lamp flashes when engine speed is raised after completion of warm-up •Engine oil pan oil level is low (suck- ing in air) •Clogged oil filter cartridge •Defective tightening of oil pipe joint, oil leakage from damaged part •Defective monitor panel •Add oil to specified level, see CHECK BEFORE STARTING •Replace cartridge, see EVERY 500 HOURS SERVICE (•Check, repair) (•Replace) Steam is emitted from top part of radiator (pressure valve) •Coolant level low, water leakage •Dirt or scale accumulated in cooling system •Clogged radiator fins or damaged fins •Defective thermostat •Loose radiator filler cap (high alti- tude operation) •Defective monitor panel •Add coolant, repair, see CHECK BEFORE STARTING •Change coolant, clean inside of cooling system, see WHEN REQUIRED •Clean or repair, see WHEN REQUIRED (•Replace thermostat) •Tighten cap or replace packing (•Replace) Engine coolant temperature caution lamp flashes Engine does not start when starting motor is turned •Lack of fuel •Air in fuel system •No fuel in fuel filter •Starting motor cranks engine slug- gishly •Defective valve compression •Add fuel, see CHECK BEFORE STARTING •Repair place where air is sucked in (•Replace pump or nozzle) •See ELECTRICAL SYSTEM (•Adjust valve clearance) Exhaust gas is white or blue •Too much oil in oil pan •Improper fuel •Add oil to specified level, see CHECK BEFORE STARTING •Change to specified fuel Exhaust gas occasionally turns black •Clogged air cleaner element •Defective nozzle •Defective compression •Defective turbocharger •Clean or replace, see WHEN REQUIRED (•Replace nozzle) (•Adjust valve clearance) (•Clean or replace, turbocharger) Combustion noise occasionally makes breathing sound •Defective nozzle •Lack of fuel (in Air) (•Replace nozzle) •Add fuel Abnormal noise generated (combus- tion or mechanical) •Low grade fuel being used •Overheating •Damage inside muffler •Excessive valve clearance •Change to specified fuel •See item “Indicator of water temperature gauge is in red range on right side of gauge“.
(•Replace muffler) (•Adjust valve clearance)