TROUBLESHOOTING OPERATION CHASSIS 3 q ( ): Always contact your Komatsu distributor when dealing with these items. q In cases of problem or causes which are not listed below, contact your Komatsu distributor for repairs. 3-144 Problem Main causes Remedy Oil pressure in torque converter fails to rise •Improper tightening of oil pipe, pipe joint, air leaking in or oil leaking out because of damage •Wear, scuffing of gear pump •Insufficient oil in power train case •Clogged oil filter element strainer in power train case •Check, repair (•Check, replace) •Add oil to the specified level. For details, see CHECK BEFORE STARTING •Clean.
For details, see EVERY 500 HOURS SERVICE Torque converter is overheated •Clogged radiator •Engine coolant temperature is high •Clogged oil cooler •Oil pressure too low •Lack of flow of lubricant caused by wear of power train gear pump •Clean radiator core •See ENGINE related parts (•Clean or repalce) •Go to “Oil pressure in torque con- verter fails to rise“ (•Replace gear pump) Torque converter oil temperature gauge does not work •Defective oil temperature gauge •Defective contact in wiring connec- tion (•Replace oil temperature gauge) (•Check, repair) Lacks drawbar pull (machine does not pick up speed) •Lack of engine horsepower •Oil pressure in torque converter is too low •See ENGINE related parts •Go to “ Oil pressure in torque con- verter fails to rise“ Machine will not move when steer- ing, forward-reverse, gear shift lever is placed in FORWARD •Insufficient oil in power train case •Transmission oil pressure does not rise •Defective Brake •Defective lever wiring •Parking brake lever is in LOCK position •Add oil to specified level.
For details, see CHECK BEFORE STARTING •Go to oil pressure in torque con- verter fails to rise (•Adjust linkage) (•Check, repair) •Set to FREE position Does not steer even when steering is operated •Defective lever wiring •Abnormal HSS pump •Abnormal HSS motor (•Check, repair) (•Check, replace) (•Check, replace) Machine doesn't stop when brake pedal are depressed •Defective brake adjustment (•Adjust linkage) (•Check brake pressure) Track comes off •Track is too loose •Adjust track tension. For details, see WHEN REQUIRED Sprocket develops abnormal wear •Track is too loose or too tight •Adjust track tension.
For details, see WHEN REQUIRED Machine does not travel in straight line •Defective adjustment of HSS con- troller •Abnormal HSS pump (•Adjust) (•Replace) Blade rises too slowly or does not rise at all (or blade tilts too slowly) •Lack of hydraulic oil •Defective hydraulic pump •Work equipment lock lever is in LOCK position •Add oil to specified level. For details, see EVERY 250 HOURS SERVICE •Check •Set to FREE position