MAINTENANCE GUIDE TO MAINTENANCE DUSTY WORKSITES: When working at dusty worksites, do as follows: q Inspect the dust indicator frequently to see if the air cleaner is dirty or clogged. q Clean the radiator core frequently to avoid clogging. q Clean and replace the fuel filter frequently. q Clean electrical components, especially the starting motor and alternator, to avoid accumulation of dust. q When inspecting or changing the oil, move the machine to a place that is free of dust to prevent dirt from get- ting into the oil. AVOID MIXING OILS: If a different brand or grade of oil has to be added, drain the old oil and replace all the oil with the new brand or grade of oil.
Never mix different brand or grade of oil. PRECAUTIONS FOR OPENING AND CLOSING ENGINE SIDE COVER: q Open the engine side cover all the way and ensure that it is locked open before letting go. q When standing on the track to open the engine side cover, bend at the knees and open the cover in a standing posi- tion to avoid back strain. q Before opening the cab door, always close the engine side cover. If the lock for the engine side cover is not released, it will not close. If any attempt is made to close it without releas- ing the lock, the gas damper may break. When closing the cover, push the orange button in the cen- ter of the gas damper (1) to release the lock, then close the cover.
LOCKING THE INSPECTION COVER: Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with inspection cover not locked in position, there is a danger that it may be suddenly blown shut by the wind and cause injury to the worker. HYDRAULIC SYSTEM-AIR BLEEDING: After repairing or replacing hydraulic equipment or after removing the hydraulic piping, it is necessary to bleed the air from the circuit. For details, see “PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SYSTEM (4-42)“. 4-3