GUIDE TO MAINTENANCE MAINTENANCE PRECAUTIONS WHEN INSTALLING HYDRAULIC HOSES: q When removing parts at locations where there are O-rings or gasket seals, clean the mounting surface, and replace with new parts. When doing this, be careful not to forget to assemble the O-rings and gaskets. q When installing the hoses, do not twist or bend them into loops with a small radius. This will cause damage to the hose and drastically reduce its service life. CHECKS AFTER INSPECTION AND MAINTENANCE WORK: If you forget to perform the checks after inspection and maintenance, unexpected problems may occur, and this may lead to serious injury or property damage. Always do the following:
q Checks after operation (with engine stopped) q Have any inspection and maintenance points been forgotten? q Have all inspection and maintenance items been performed correctly? q Have any tools or parts been dropped inside the machine? It is particularly dangerous if parts are dropped inside the machine and get caught in the lever linkage mechanism. q Is there any leakage of coolant or oil? Have all nuts and bolts been tightened? q Checks when engine is running q For the checks when the engine is running, see “TWO WORKERS FOR MAINTENANCE WHEN ENGINE IS RUNNING (2-28)“ in the SAFETY section, and take care of safety sufficiently. q Check that the inspected and maintained parts work normally.
q Raise the engine speed and check for fuel leakage and oil leakage. 4-4