Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

SERVICE PROCEDURE MAINTENANCE 4. Clean the interior of the air cleaner body, cover (3) and evacuator valve (6). NOTICE The inner element must not be used again even after cleaning. When replacing the outer element, replace the inner element at the same time. 5. Direct dry compressed air (Max. 0.69 MPa (7 kgf/cm2, 99.4 PSI)) from the inside of the outer element along its folds. Then direct the compressed air from the outside along the folds, and again from the inside. 6. Replace any outer element which has been cleaned 6 times or used for one year. Replace the inner element at the same time. 7.

Even if the outer element has not been cleaned 6 times, if the yellow piston in the dust indicator goes to the 5 kPa position immediately after cleaning (when the engine is running at high idling, replace both the inner and the outer element. REMARK On machines equipped with a high suction resistance precleaner or rain cap, if the yellow piston goes above the 7.5 kPa position immediately after cleaning, replace both the inner and the outer element. 8. If small holes or thinner parts are found on the element when it is checked by shining a light through it after clean- ing, replace the element. NOTICE When cleaning the element, do not hit or beat it against anything.

Do not use an element whose folds, gasket or seal are damaged. 9. Before installing the outer element, check that the inner element is fitted securely. If the inner element is not fitted securely, push it in properly. When installing the cover (3), check O-ring (7) and replace it if there are any scratches or damage. 10. Set the cleaned outer element in position, then secure cover (3) with mounting clips (2). 4-20 CAUTION