Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

MAINTENANCE SERVICE PROCEDURE REVERSE AND REPLACE END BITS AND CUTTING EDGES 4 When carrying out this operation, it is extremely dangerous if the work equipment is moved by mistake. Set the work equipment in a stable condition, stop the engine, and set the work equipment lock lever securely to the LOCK position. Reverse or replace the end bits and cutting edges before it is worn out to the blade end. 1. Raise the blade to a proper height, apply a block under the frame to prevent the blade from falling. 2. Set the work equipment lock lever to the LOCK position and stop the engine. 3. Measure the wear of the end bit and cutting edge in accordance with the wear standards given below.

Wear standards Wear standards Unit [mm (in)] The symbols in the work equipment column have the following meaning. A: Power angle, powertilt dozer (D61EX) B: Power angle, powertilt dozer (D61PX) C: Powertilt dozer (D61PX) D: Semi-U blade (D61EX) REMARK If the cutting edge and the end bit on both sides are worn out, replace with new one. If it has been worn out up to the fitting surface, repair the fitting surface and then reverse or replace. 4. Remove the cutting edge and the end bit and clean the mounting surface. 5. Reverse or replace the cutting edge and the end bit when worn out. 4-29 WARNING Item Judgement standard No.

Measurement point Work equipment Standard dimension Repair limit 1 Height of outside of end bit A 237 (9.3) 204 (8.0) B 237 (9.3) 204 (8.0) C 237 (9.3) 204 (8.0) 2 Width of end bit A 325 (12.8) 300 (11.8) B 325 (12.8) 300 (11.8) C 325 (12.8) 300 (11.8) 3 Height of inside of end bit A 204 (8.0) 187 (7.4) B 204 (8.0) 187 (7.4) C 204 (8.0) 187 (7.4) 4 Height of cutting edge (from center of bolt mounting hole to end face) A 102 (4.0) 85 (3.3) B 102 (4.0) 85 (3.3) C 102 (4.0) 85 (3.3)