Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

SERVICE PROCEDURE MAINTENANCE 6. Remove nut (1) and bolt (2), then replace or reverse the cutting edge and the end bit. 7. Install the cutting edge to the blade and tighten the bolt temporarily. Press the blade against the ground to elimi- nate the play of bolt (2), then tighten the bolt to the speci- fied torque. Nut tightening torque: Power angle, powertilt dozer (EX,PX): 461 ± 69 N·m (47 ± 7 kgf·m, 340 ± 51 lbft) Powertilt dozer(PX): 461 ± 69 N·m (47 ± 7 kgf·m, 340 ± 51 lbft) Semi-U dozer (EX) (cutting edge): 461 ± 69 N·m (47 ± 7 kgf·m, 340 ± 51 lbft) Semi-U dozer (EX) (end bit):

745 ± 108 N·m (76 ± 11 kgf·m, 549.7 ± 79.6 lbft) If bolt (2) and nut (1) are damaged, replace them with new ones at the same time. 8. After several hours of running, retourque the nuts. 4-30