MAINTENANCE SERVICE PROCEDURE CHECK IDLER OIL LEVEL, ADD OIL 4 If the oil level in the idler is low, new oil must be added, and the machine body must be inclined in this case. Since this work is dangerous, ask your Komatsu distributor. If the oil level in the idler is low, noise will be generated and there will be seizure, so check the oil level and add oil as follows. INSPECTION 1. Remove bolt (1), then remove guide plate (2) and shim (3). REMARK When removing shim (3) keep it in a safe place and be careful not to lose it. 2. Loosen plug (4) slowly. If oil oozes through the threads at this time, the quantity of oil is sufficient. Tighten plug (4). 3.
If any oil does not flow out when plug (4) is removed, the quantity of oil is insufficient. In this case, ask your Komatsu distributor for add oil. 4. Install guide plate (2) and shim (3) with bolt (1). REMARK When installing guide plate (2), install the same number and thickness of shim (3) as removed in Step 1. The optimum clearance may be obtained, if the adjustment is made at the same time. For details of adjusting the shim thick- ness, see “ADJUST IDLER CLEARANCE (4-38)“. 4-37 WARNING