SERVICE PROCEDURE MAINTENANCE ADJUST IDLER CLEARANCE 4 Since the idlers are forced to move forward and backward by an external force guide plates will be worn out. Wear of these plates will cause the vibration of idlers from side to side or inclination of the idlers, and running off of track links from the idlers or unevenly worn idler and links may result. Therefore, adjust the idlers according to the following procedure. ADJUSTMENT 1. Travel for 1 or 2 meters on flat ground, then measure clear- ance (A) between track frame (1) and guide plate (2) (4 places: left, right, inside, outside). 2.
If the clearance (A) exceeds 4.0 mm (0.16 in), loosen bolt (3), and pull out the shim to adjust the clearance at one end to 0.5 to 1.0 mm (0.02 to 0.04 in). Thickness of one shim is 1.0 mm (0.04 in). CHECK LINK PITCH 4 If the measured value comes close to the repair limit, please contact your Komatsu distributor. 1. Insert a wooden block between track shoe and sprocket to take up the slack in track shoes. 2. Measure the pitch length (L) of 4 links at a straight portion at least 2 links from master pin (A). Divide this measure- ment by four to obtain the link pitch. q Basic link pitch (P): 190 mm (7.5 in) q Link pitch limit for turning:
193 mm (7.6 in) There is no link window on the master link. REMARK The measured value under decimal of link pitch is different from the basic value depending upon the precision of measure or the tolerance of product even if it isn't worn out. Don't judge it's worn out too soon, do it with the trend of mea- sured value after that. 4-38