Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

SERVICE PROCEDURE MAINTENANCE ADJUST PLAY IN CENTER BALL 4 (Power angle, power tiltdozer only) When adjusting, always set the work equipment lock lever to the LOCK position except when operating the blade. It is necessary to adjust the shim at the center ball in the following cases. q When there is play at the center ball. q When assembling the blade again after it has been removed for transportation of the machine. If the adjustment is not carried out, the operating response will become poor. In addition, sand and soil will enter the ball portion and cause damage or premature wear of the ball. Adjust as follows.

Adjust with shims so that the play at the center ball is 0.2 - 0.7 mm (0.008 - 0.028 in). 1. Remove bolt (1), then loosen bolt (2). 2. Remove excess shims (3) (1 or 2 pieces), then tighten bolts (1) and (2) temporarily. 3. Angle and tilt the blade. q If the blade moves smoothly without making any squeaking sound, the adjustment is complete. q If there is a squeaking sound or the blade does not move smoothly, add shims. q If the play at the ball is still excessive, remove more shims. 4. If the work equipment moves smoothly, tighten bolts (1) and (2). Tightening torque: 588 - 1030Nm (60 - 105kgm, 434- 759lbft) Standard shim thickness (A): 6 - 8 mm (0.2 - 0.3 in) Thickness of shims:

0.5 mm (0.02 in), 1.0 mm (0.04 in) 4-40 WARNING