Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

MAINTENANCE SERVICE PROCEDURE GREASE EQUALIZER BAR SIDE PIN 4 Greasing points Grease fitting (1): Front of carrier roller support on left side of machine Grease fitting (2): Rear of carrier roller support on right side of machine 1. Remove all dirt from the top of the track frame and cover. 2. Clean the grease fitting, then supply grease to that fitting with a grease pump. REMARK Supply 3 shots of grease (Operate the grease pump lever 3 times) to each grease fitting, and check that grease is newly discharged through the seal lip. If grease is not newly discharged through the lip, continue supplying grease until it is discharged. GREASE EQUALIZER BAR CENTER PIN 4 (1 place) 1.

Open the engine side cover on the left side of the chassis. 2. Clean the grease fitting indicated with the arrow, then sup- ply grease to that fitting with a grease pump. 4-47