Komatsu — Komatsu K EAM04 9 700 T Operation and Maintenance Manual for Bulldozers

SERVICE PROCEDURE MAINTENANCE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL 4 The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Remove oil level plug (1) and check whether the final drive case is filled with oil to lower edge of the plug hole. 2. If the oil level is too low, add engine oil through the plug hole until the oil overflows. CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL 4 q The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work.

q When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. NOTICE q Do not add oil if the level is above the H line. This will damage the hydraulic equipment and cause the oil to spurt out. q Always lock the cap with the key. 1. Lower blade to the ground and stop the engine. Wait for 5 minutes before checking oil level. Oil level should be between the H and L in sight gauge (G). 2. If the level is below the L mark, add oil through oil filler (F). 3. After adding oil, be sure to screw on the oil filler cap and lock it with the key. 4-48 WARNING WARNING