AIR SUSPENSION SEAT ATTACHMENTS, OPTIONS (C) Adjusting seat height The seat height adjustment uses an air system, and it can be adjusted steplessly. When adjusting the height, pull lever (3) up fully or push it down fully (when pulling it up, pull it until a click is felt). When the seat is set at the desired height, release the lever. If the lever is kept pulled up, the position where the seat does not rise any further is the maximum height. When the seat reaches the maximum height, the suspension automatically goes down slightly to secure the amount of movement of the lever.
If the operator raises his body from the seat or changes the amount of weight applied to the seat during adjust- ment, the air in the suspension may be discharged. Amount of adjustment: 80 mm (3.2 in) (D) Setting seat for weight Pull lever (3) up fully (pull it until a click can be felt). When the lever is released, the weight adjustment is carried out automatically. To ensure that the weight adjustment is carried out correctly, the operator should sit in the nor- mal operating position when operating the lever. If the operator raises his body from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension may be discharged.
When operators change shifts, the new operator should pull lever (3) up fully (pull it until a click it is felt). When the lever is released, the weight adjustment is carried out automatically. If lever (3) is pulled lightly, the weight adjustment starts, but always pull the lever up fully (pull it until a click is felt) before releasing it. (E) Fore-and-aft adjustment of seat cushion Operate lever (4) up, set the seat cushion to the desired position, then release the lever. Fore-and-aft adjustment: 60 mm (2.4 in) (F) Adjusting reclining angle Move lever (5) up and move the backrest to the front or rear. Push your back against the backrest when carrying out this adjustment.
If your back is not pressing against the backrest, the backrest may suddenly spring forward. Amount of adjustment Forward tilt: 20 degrees (over 20 degrees is free) Rear tilt: 60 degrees REMARK The seat can be reclined more when the seat is pushed to the front. The amount of reclining decreases as the seat is pushed back, so when moving the seat back, return the seatback to the upright position. NOTICE If the seat back is reclined too far, the seat back may hit the rear glass, so use it in a position where it does not contact the glass. 6-10