ATTACHMENTS, OPTIONS AIR SUSPENSION SEAT AIR SUSPENSION SEAT 6 ADJUSTMENT 6 When adjusting the position of the operator's seat, always set the work equipment lock lever to the LOCK position to prevent any accidental contact with the control levers. q Always adjust the operator's seat before starting each operation or when the operators change shift. q When adjusting the seat, put your back against the backrest and adjust to a position where the brake pedal can be fully depressed. NOTICE There is danger of damage to the air compressor, so do not keep lever (3) operated continuously for more than 1 minute.
Adjustments (C), (D), and (I) use the air compressor built into the seat, so turn the engine starting switch to the ON position when carrying out the adjustment. (A) Fore-and-aft adjustment Pull lever (1), set the seat to a position where it is easy to oper- ate, then release the lever. Fore-aft adjustment: 170 mm (6.7 in) (17 stages) (B) Adjusting seat angle Move lever (2) up, move the seat cushion at the front up or down to set to the desired position, then release the lever. Amount of adjustment Forward tilt: 3 degrees Rear tilt: 11 degrees 6-9 WARNING