© 1084 Valve Seat Ring Removal / Refitment Job Card No.: 01.13.01 Page 1 of 3 Engine: S/BVM 628 Filing No.: 0178-08-10 1854 In accordance with the engine equipment specifica- Job Cards: tio - depending on the type of fuel stated when the - 01.05.01 engine is ordered - the cylinder heads can be provi- - 01.07.01 ded with cooled or uncooled exhaust valve-seat rings. Inlet valve-seat rings are always uncooled. Tools: - Standard tools, - Puller tool for fitting and removing valve-seat rings (Section1.8). - Locking compound Deutz DW 57 (Section 3.6). Job: First remove valve (Job Card 01.05.01).
Removing the Uncooled Valve-Seat Ring - Fig.1 - Clean deposits out of the groove between valve-seat ring and cylinder head and insert circlip (6). Place puller bush (5) through inlet or exhaust passage respectively onto the circlip and, from the combusti- on chamber side, screw plate (7) onto the puller bush. This is necessary to ensure that the circlip is not pressed out of its groove during the pulling operation. Now screw the hex. bolt (4), together with washers (2), bearing (3) and puller support (1) into the puller bush. Pull out the valve-seat ring by tightening the hex. bolt. Clean receiving bore in the cylinder head © 25 138 2 without damaging it. Fig. 1 © 25 138 2 © 25 138 2