© 1084 Job Card No.: 01.13.01 Page 2 of 3 Valve Seat Ring Removal / Refitment Engine: S/BVM 628 Filing No.: 0178-08-10 1854 Removing the Cooled Valve-Seat Ring - Fig . 2 Place puller bush (5) through the exhaust passage onto the valve-seat ring. From the combustion chamber side, screw hex. bolt (4), together with washer (2), bearing (3) and puller support (1), into the puller bush. Pull out the valve-seat ring by tightening the hex. bolt. Clean receiving bore in the cylinder head without damaging it. Before fitting, gauge the receiving bore in the cylinder head. If the diameter of the receiving bore in the case of:
- uncooled valve-seat ring is greater than 79,03 mm, - cooled valve-seat ring is greater than 72,03 mm © 25 137 2 and/or at the bottom is greater than 91,03 mm, Fig. 2 an oversize ring must be fitted. Further details can be obtained from our Deutz Service Departments. Canting or the formation of burrs must be avoided! Hammering-in instead of pulling-in with puller tool is not permisible! Fitting the Uncooled Valve-Seat Ring - Fig. 3 - Lightly oil seat ring on outer periphery and push it into the cylinder head. Mount threaded spindle (1), together with hex. nut (6), washers (5), bearing (4) and bush (3). The seat ring is pulled onto its seat by tightening the hex. nut (6).
Ensure full seating! A repetition of the pulling-in operation results in a certain enlargement of the receiving bore in the cylin- der head, so that an oversize ring may then be necessary. © 25 140 2 Fig. 3 © 25 137 2 © 25 137 2 © 25 140 2 © 25 140 2