©0683 Main Bearing Removal Job Card No.: 02.07.01 Page 3 of 3 Engine: S/BVM 628 Filing No.: 0178-01-10 1836 Removing the Shells Take out lower bearing shell and make sure that its lug is provided with a marking on the back. NIf upper shell (14) cannot be pushed out by hand, insert driver pin (15) into oil passage 'X' of crankshaft (1) and carefully turn crankshaft in the arrowed direc- tion (Fig. 5) until the flat of pin (15) contacts the joint of upper shell (14). Carefully turn farther until the upper shell can be removed by hand. Inspect upper shell for the lug marking (see job 02.08.01). Provide mark if missing. Remove pin (15).
To keep dust, etc., out of the crankshaft oil passage, close the holes with a non-transparent adhesive tape, so that it will be noticed for removal when reassembly is done. DEMEKKİ BİRİLERİ TRANSPARENT KOYUP SONRA UNUTMUŞ © 51 259 0 Shell wear patterns: See Job Card 02.04.01. Fig. 5 T KOYUP SONRA UNUTMUŞ © 51 259 0 © 51 259 0