© 0883 Section: 3.3 Specification Data Page: 3-1-04 Engine: S/BV 6/8/9 M 628 Separate standby oil pump: - capacity 6-cyl.: 24 - 30 m3/h 8-cyl.: 30 - 35 m3/h 9-cyl.: 35 - 40 m3/h - Pressure 5 bar Oil Sump Inclinations and Capacities Dipstick with 3 marks Dipstick with 3 marks Connections for low-level tank © 51 201 0 Max. engine installation angle α ± = 3° Max. sump inclination (incl. installation angle) α ± = 10° Max. permanent inclination β ± = 22,5° Max. temporary inclination β ± = 30° (starting 22°, turbocharger will lose some oil) 6-cyl. 8-cyl 9-cyl max.
Top mark α = 0° 615 800 895 β = 0° *3 Oil capacity of level deep oil sump (litres) 2) Medium mark α = ±10° *1 525 680 760 oil β = 0° *3 min. Bottom mark α = ±10° 405 525 590 β = 0° *1) Where sump inclinations α ± are below 10°, the oil level can be kept at a corresponding level between the top and medium dipstick mark to ensure maximum oil supply to the engine and hence increase oil change intervals . (1° less inclination allows for approx. 10 mm higher level above medium mark.) *2) Sump lubrication for heavy fuel requires min. 0,82 lit/kW *3) Due to inclined dipstick, correct maximum distance can be obtained only with β = 0°.
Dipstick with 3 marks Dipstick with 3 marks Connections for low-level tank © 51 201 0 © 51 201 0 Max. engine installation angle α ± = 3° Max. sump inclination (incl. installation angle) Max. permanent inclination α ± = 10° β ± = 22,5° Max. temporary inclination (starting 22°, turbocharger will lose some oil) β ± = 30° max. Top mark α = 0° β = 0° *3 Oil capacity of level deep oil sump (litres) 2) Medium mark α = ±10° *1 oil β = 0° *3 min. Bottom mark α = ±10° β = 0° 6-cyl. 8-cyl 9-cyl 615 800 895 Oil capacity of level deep oil sump (litres) 2) Medium mark α = ±10° *1 oil β = 0° *3 525 680 760 405 525 590