Deutz — 4.6.1 Drive type "Fixed-pitch propeller and comparable drives"

© 0996 Operating the Engine Section: 4 Page: 4-5-01 Engine: S/BVM 628 4.6 Run-in Instructions Engines which leave the manufacturer's works have been run in; thus run-in at site is not necessary. Following servicing work on main and big-end bearings, pistons, piston rings and cylinder liners the engine must be run in again. The following run-in programs apply to the different drive types: 4.6.1 Drive type "Fixed-pitch propeller and comparable drives" (Engine load is mainly dependent on speed, n = variable) G Start engine, sections 4.1 and 4.2, and run at low speed for 5 minutes. G Stop engine, section 4.4. G Check bearings and crankshaft.

If the engine has warmed up noticeably, the cause must be locked for immediately and remedied. G Start engine again and r un at low speed for 30 minutes. G Stop engine again. G Check bearings and crankshaft. If the engine has warmed up noticeably, the cause must be locked for immediately and remedied. G Start engine again and increase speed gradually according to the following table. Run-in time Engine speed in % in minutes of rated speed 60 35 30 45 60 55 15 35 45 70 15 55 45 80 With propeller drives, this part of the 15 65 program must not be run with the 45 90 vessel tied on! 15 70 45 95 G Check engine operating data and compare with those of repair / acceptance test record.

In case of major deviations cause must be locked for and remedied. During the following 24 hours engine should not be run with control rod set to fuel stop and reduced speed, nor with overload, in order to intensify run-in effect. Run-in time in minutes Engine speed in % of rated speed 60 35 30 45 60 55 15 35 45 70 With propeller drives, this part of the program must not be run with the vessel tied on! 15 55 45 80 15 65 45 90 15 70 45 95