Deutz — 4.6.2 Drive type "C.P. propeller with shaft generator, electric generators and comparable drives"

© 0996 Section: 4 Operating the Engine Page: 4-5-02 Engine: S/BVM 628 4.6.2 Drive type "C.P. propeller with shaft generator, electric generators and comparable drives" (Engine load adjustable independent of speed, n = constant) G Start engine, sections 4.1 and 4.2, and run at low speed for 5 minutes. G Stop engine, section 4.4. G Check bearings and crankshaft. If the engine has warmed up noticeably, the cause must be locked for immediately and remedied. G Start engine again and r un at low speed for 30 minutes. G Stop engine again. G Check bearings and crankshaft.

If the engine has warmed up noticeably, the cause must be locked for immediately and remedied G Start engine again and increase speed gradually according to the following table. Run-in time Engine speed in % Engine power in % in minutes of rated speed of rated power 60 30 - 50 bis 5 30 50 5 - 10 60 100 bis 20 15 30 - 50 bis 5 45 100 30 - 40 15 100 bis 25 With propeller drives, 45 100 50 - 60 this part of the program 15 100 20 - 30 must not be run with 45 100 80 - 90 the vessel tied on! 15 100 30 - 40 45 100 80 - 90 G Check engine operating data and compare with those of repair / acceptance test record. In case of major deviations cause must be locked for and remedied.

During the following 24 hours engine should not be run with control rod set to fuel stop and reduced speed, nor with overload, in order to intensify run-in effect. Run-in time in minutes Engine speed in % of rated speed Engine power in % of rated power 60 30 - 50 bis 5 30 50 5 - 10 60 100 bis 20 15 30 - 50 bis 5 45 100 30 - 40 With propeller drives, this part of the program must not be run with the vessel tied on! 15 100 bis 25 45 100 50 - 60 15 100 20 - 30 45 100 80 - 90 15 100 30 - 40 45 100 80 - 90