Komatsu — SWITCHES

OPERATION EXPLANATION OF COMPONENTS E.C.S.S. SWITCH 0. If the machine is traveling or the work equipment is raised, the moment the E.C.S.S. switch is turned ON, the work equipment will move. If the E.C.S.S. is switched on, the work equipment may move. Never turn on the E.C.S.S. switch ON during inspection or maintenance. The work equipment will move and this will create a dangerous situation. NOTICE Always stop the machine and lower the work equipment to the ground before operating the E.C.S.S. switch. When carrying out inspection and maintenance, first lower the work equipment to the ground, then turn the E.C.S.S. switch OFF before starting the inspection and maintenance operation.

When carrying out leveling work, turn the E.C.S.S. switch OFF. This switch (21) is used to turn the E.C.S.S. ON and OFF. Position (a): ON The pilot lamp lights up and the E.C.S.S. is actuated. Position (b): OFF The E.C.S.S. is not actuated. REMARK The E.C.S.S. is a device that uses the hydraulic spring effect of an accumulator to absorb the vibration of the chassis during travel and allows the machine to travel smoothly and at high speed. When traveling in 1st, the E.C.S.S. is not actuated. When the speed range is 2nd to 4th, and the travel speed becomes more than 5 km/h (3.1 MPH), the E.C.S.S.

is automatically actuated; when the travel speed goes below 3 km/h (1.9 MPH), it is automati- cally disengaged. 3-47 WARNING