Komatsu — SWITCHES

EXPLANATION OF COMPONENTS OPERATION EMERGENCY STEERING SWITCH 0. This switch (22) is the manual control switch for the emergency steering. Even when the engine has stopped, steering operations are made possible by pressing this switch. Position (a): ON The pilot lamp inside the switch and the emergency steering pilot lamp on the machine monitor light up and it becomes possible to operate the steering. When the switch is released, it automatically returns to its origi- nal position. Actuate the emergency steering only in cases of emergency or when checking the function. The time for operating the emergency steering continuously is a maximum of 60 seconds.

When using the emergency steering, travel at a speed of less than 5 km/h (3.1 MPH). For details, see “EMERGENCY STEERING ( 3-95 )“ in the OPERATION section. COOLING FAN REVERSE ROTATION SWITCH 0. This switch (23) is used to rotate the cooling fan in the reverse direction when cleaning the radiator. Position (a): ON The pilot lamp inside the switch and the cooling fan reverse rotation pilot lamp on the machine monitor light up. At the same time, “COOLING FAN REVERSE“ is displayed on the character display, and the fan is set to rotate in reverse. Position (b): OFF The cooling fan is set to rotate in the normal direction. Stop the engine before operating the switch.

Switching normal rotation -> reverse rotation: With the engine stopped, do as follows: Starting switch ON-> reverse rotation switch ON -> check machine monitor -> starting switch START -> fan reverse rotation Switching reverse rotation -> normal rotation: Engine at low speed -> starting switch OFF -> starting switch ON-> reverse rotation switch OFF -> starting switch START -> fan normal rotation For details, see “CLEAN FINS BY ROTATING COOLING FAN IN REVERSE ( 4-28 )“ in the WHEN REQUIRED section.

REMARK When the engine is running, even if the switch is pressed, the direction of rotation of the fan does not change, but the cooling fan reverse rotation pilot lamp on the machine monitor flashes. Use the reverse rotation of the fan only for cleaning. For normal operations, rotate the fan in the nor- mal direction. If operations are carried out with the fan rotating in the reverse direction, the machine will not display its full function and will tend to overheat. 3-48