Komatsu — CONTROL LEVERS, PEDALS

OPERATION EXPLANATION OF COMPONENTS REMARK The length of the lever can be adjusted to 3 stages (posi- tions (A), (B), (C)). To adjust the length, remove the screw at the bottom of the lever knob, slide the knob to the desired position, then tighten the screw again. (The lever is installed to position (B) when it is shipped from the factory.) AUTOMATIC SHIFT 0. Automatic gear shifting canbe carried out in the 2nd and 4th speed range of the four forward and reverse speeds depending on the travel conditions.

Position (a):1st Position (b):2nd Position (c):3rd Position (d):4th The range of speeds during automatic gear shifting is deter- mined by the position of the gear shift lever as shown in the chart on the right. REMARK The 1st position for the gearshift lever fixes the trans- mission in 1st. There is no automatic shifting of the transmission. When shifting down from 2nd to 1st, press the kick- down switch on the lift arm control lever. If the transmission is in auto-shift and the travel speed is below 12.5 km/h (7.8 MPH) in any speed range when traveling in either forward or in reverse, the kick-down switch is actuated and makes it possible to shift down to 1st.

This makes it easy to carry out load and carry opera- tions. Even if the travel speed is more than 12.5 km/h (7.8 MPH), this switch can be used to shift the transmission down. Each time the kick-down switch is pressed, the speed range will shift down one range at a time (when in 4th: F4 -> F3 -> F2 when in 3rd: F3 -> F2). 3-53