Komatsu — CONTROL LEVERS, PEDALS

EXPLANATION OF COMPONENTS OPERATION To set to the desired speed range when traveling uphill or downhill, or when carrying out grading, do as follows. When fixing the speed range Press the HOLD switch on the rift arm control lever. The speed range is fixed at the speed range displayed on the transmission indicator on the main monitor. When shifting up or down from set speed range Shift gear with the gear shift lever. REMARK When the transmission has been shifted down from 2nd to 1st with the kickdown switch, it will shift up from 1st to 2nd when the travel speed increases. DIRECTIONAL LEVER 0. This lever (2) is used to switch the direction of travel of the machine between forward and reverse.

When starting the engine, if the directional lever is not at the N position, the engine will not start. In this case, the central warning lamp will light up and the buzzer will sound. At the same time, “E00 SHIFT LEVER NEUT“ is displayed on the character display. Return the gearshift lever to the N position and start the engine. Position (a): FORWARD Position N: Neutral Position (b): REVERSE REMARK The length of the lever can be adjusted to 3 stages (posi- tions (A), (B), (C)). To adjust the length, remove the screw at the bottom of the lever knob, slide the knob to the desired position, then tighten the screw again.

(The lever is installed to position (B) when it is shipped from the factory.) 3-54