OPERATION OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE 0. Emergency stop If the operation is abnormal or any other trouble occurs, turn the key in the starting switch to the OFF position. If the work equipment is operated without warming up the machine sufficiently, the response of the work equipment to the movement of the control lever will be slow, and the work equipment may not move as the operator desires, so always carry out the warming-up operation. Particularly in cold areas, be sure to carry out the warming-up operation fully. BREAKING IN THE MACHINE 0. Your Komatsu machine has been thoroughly adjusted and tested before shipment.
However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to breaking-in the machine for the initial 100 hours (as indicated by the service meter). During breaking-in operations, follow the precautions described in this manual. Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds. Avoid sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency. NORMAL OPERATION 0. After starting the engine, do not immediately start operations. First, carry out the following operations and checks.
NOTICE Do not suddenly accelerate the engine before the warm- ing-up operation is completed. Do not run the engine at low idling or high idling continu- ously for more than 20 minutes. If it is necessary to run the engine at idling, apply a load from time to time or run the engine at a mid-range speed. 1. Depress accelerator pedal (1) lightly and run the engine with no load at midrange speed for about 5 minutes. 3-83 WARNING CAUTION