OPERATION OPERATION 2. To warm up the hydraulic oil only in cold areas, do as fol- lows. During the warming-up operation, check that the engine rotation is smooth, then set the safety lock of the work equipment control lever to the FREE position and move the bucket control lever in and out of the TILT position to warm up the hydraulic oil. The relief time at the tilt position should be a maximum of 10 seconds. With this operation, the oil will reach the relief pressure and this will warm up the hydraulic oil more quickly. 3. After carrying out the warming-up operation, check that the gauges and caution lamps are normal. If there is any abnormality, carry out maintenance or repair.
Run the engine under a light load until engine cooling water temperature gauge (2) and torque converter oil temperature gauge (3) are in the green range. 4. Check that there is no abnormal exhaust gas color, noise, or vibration. If any abnormality is found, please contact your Komatsu distributor. REMARK The sound of the cooling fan rotation differs according to the following conditions, but this does not indi- cate any abnormality. The cooling fan speed increases when the hydraulic oil temperature, engine coolant temperature, or trans- mission oil temperature are high.
However, when the cooling fan is rotating in reverse, it rotates at a fixed speed proportional to the engine speed, regardless of any oil or coolant temperature. 3-84