OPERATION OPERATION CHANGING DIRECTION 0. NOTICE The following describes a machine with 2-lever control. For machines with multifunction lever, see MULTI- FUNCTION LEVER ( 6-45 ). When changing direction between FORWARD and REVERSE, check that the new direction of travel is safe. There is a blind spot behind the machine, so be particularly careful when changing direction to travel in reverse. Do not switch between FORWARD and REVERSE when traveling at high speed. When switching between FORWARD and REVERSE, depress the brake to reduce the travel speed suffi- ciently, then change the direction of travel. (Max.speed for changing direction:
12 km/h (7.5 MPH)) There is no need to stop the machine even when switching between FORWARD and REVERSE. Place directional lever (1) in the desired position. REMARK There is a directional selector switch (option) which makes it possible to change the direction of travel by operating a switch. If an attempt is made to switch the direction between forward and reverse while traveling at high speed (when using 3rd or 4th), if the travel speed and engine speed are in ranges I or II in the chart on the right, the central warning lamp will light up and the buzzer will sound. At the same time, “E00 OVERRUN PROTECT“ is displayed on the character display.
If the alarm buzzer sounds, depress the brake immediately to reduce the travel speed, then operate the directional lever to switch between forward and reverse. WHEN USING AUTO-SHIFT If an attempt is made to switch the direction between forward and reverse when the auto-shift is ON, normally, the gearshift range will switch F3 -> R2, F4 -> R2, or R3 -> F2, R4 -> F2 to make it possible to move the machine off quickly. However, if an attempt is made to shift between forward and reverse when the machine is traveling at high speed such as shown in ranges I or II in the chart on the right, the central warning lamp will light up and the buzzer will sound.
At the same time, “E00 OVERRUN PROTECT“ is displayed on the character display. If the alarm buzzer sounds, depress the brake immediately to reduce the travel speed, then operate the directional lever to switch between forward and reverse. In particular, if it is attempted to switch between forward and reverse in range II, the gearshift range will not shift to 2nd, but will switch F3 -> R3, F4 -> R4, or R3 -> F3, R4 -> F4. As a result, the reduction in travel speed will be less than a range I, so care is necessary. REMARK If the gearshift lever is operated slowly or is stopped midway between the forward and reverse directions, “E01 MAINTENANCE“ may be displayed on the character display.
In this case, there is no failure, but try to operate the directional lever so that the change in direction is completed within 2 seconds. 3-90 WARNING