OPERATION OPERATION SEMI AUTO DIGGING OPERATIONS 0. SEMI AUTO DIGGING OPERATIONS 0. Semi auto digging controls the bucket tilt operation automatically in order to make bucket operations easier for the operator and reduce operator fatigue. METHOD OF OPERATION 0. 1. Turn the semi auto digging switch on the right switch panel ON (select SOFT or HARD). When the switch is turned ON, the pilot lamp inside the switch lights up. REMARK For details of the selection of SOFT or HARD, see “SELECTING DIGGING PATTERN ( 3-102 )“. 2.
Lower the bucket to the ground in the same way as for nor- mal digging operations, drive the machine forward, push the bucket into the rock while raising the lift arm to insert the tip of the bucket into the rock, then return the lift arm lever to HOLD, and the bucket will automatically start the tilt opera- tion. In addition, in digging operations where the lift arm lever is pulled and enters the lift detent, if there is hydraulic stall of the lift arm, the tilt operation will start, and the lift arm RAISE speed will be then held at the most suitable speed. During automatic digging, the semi auto digging pilot lamp on the main monitor lights up. SELECTING DIGGING PATTERN 0.
The following 2 modes can be selected for operating the bucket tilt. The semi auto digging switch on the right switch panel is used to select the mode. (1) SOFT mode This mode is effective when handling crushed rock or other light load materials. The bucket tilt actuation is controlled continuously. (2) HARD mode This mode is effective when handling heavy load materials. The bucket tilt actuation is controlled intermittently. MANUAL OPERATION DURING AUTOMATIC CONTROL 0. It is possible to operate the tilt or dump lever during automatic operation of the bucket tilt. The amount of operation of the lever is added to the bucket speed being controlled by the system. END OF CONTROL 0.
When the bucket reaches the end of the tilt, the control ends. 3-102