Komatsu — WARMING-UP OPERATION FOR STEERING HYDRAURIC CIRCUIT IN COLD WEATHER

OPERATION COLD WEATHER OPERATION WARMING-UP OPERATION FOR STEERING HYDRAURIC CIRCUIT IN COLD WEATHER 0. If the steering lever is operated and stopped while the oil temperature is low, there may be a time lag before the machine stops turninig. In this case, perform the warm-up operation in a wide place. Do not relieve the hydraulic oil in the circuit continuously for more than 5 seconds. When the temperature is low, do not start the operation of the machine immediately after starting the engine. Warming up steering hydraulic circuit Slowly operate the steering lever to the left and right to warm up the oil in the steering valve.

(Repeat this opera- tion for about 10 minutes to warm up the oil.) NOTICE Operate the steering lever a little and stop in that position. Then, confirm that the machine is being steered by an angle eqivalent to the amount that the steering lever is operated RECOMMENDED OIL 0. Change oil according to the following table, depending on an ambient temperature. If SAE5W-20CD is used in the cold season, replace it with SAE10WCD after 3-123 WARNING RESERVOIR KIND OF FLUID AMBIENT TEMPERATURE Hydraulic system Engine oil -22 -4 14 32 50 68 86 104 122°F 30 -20 -10 0 10 20 30 40 50°C SAE 10WCD SAE 5W-20CD