Komatsu — AFTER STORAGE

LONG-TERM STORAGE OPERATION LONG-TERM STORAGE 0. BEFORE STORAGE 0. When putting the machine in storage for a long time, do as follows. Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select level ground and cover the machine with a sheet. Completely fill the fuel tank, lubricate and change the oil before storage. Apply a thin coat of grease to the metal surface of the hydraulic piston rods. Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it sepa- rately. If the ambient temperature is expected to drop below 0°C (32°F), add antifreeze to the cooling water.

Since Komatsu genuine super coolant (AF-ACL) is added normally, it may be unnecessary to change when the temperature is above -10°C (14°F). If it drops below 10°C (14°F), see “CLEAN INSIDE OF COOLING SYS- TEM ( 4-21 )“ for the adjustment of concentration ratio. Lock each control lever and pedal with the lock lever and pedal lock. DURING STORAGE 0. If it is unavoidably necessary to carry out the rust-preventive operation while the machine is indoors, open the doors and windows to improve ventilation and prevent gas poisoning. During storage, always operate the machine once a month so that a new film of oil will be coated over movable parts and component surfaces.

At the same time, also charge the battery. When operating the work equipment, wipe off all the grease from the hydraulic cylinder rod. If the machine is equipped with an airconditioner, operate it for 3 to 5 minutes once a month to lubricate each portion of its compressor. Be sure to idle the engine at low speed for this purpose. Also, check the quantity of refrigerant twice a year. AFTER STORAGE 0. NOTICE If the machine is to be used when the monthly rust prevention operation has not been carried out, please contact your Komatsu distributor. When using the machine after long-term storage, do as follows before using it. Wipe off the grease from the hydraulic cylinder rods.

Add oil and grease to all places. When a machine is stored for a long period, moisture in the air will get into the oil. Check the oil before and after starting the engine. If there is water in the oil, change the oil. 3-124 WARNING