Komatsu — CHECK, CLEAN, OR REPLACE AIR CLEANER ELEMENT

MAINTENANCE SERVICE PROCEDURE CLEANING OR REPLACING OUTER ELEMENT 0. 1. 1. Open the top cover at the front of the engine side cover on the right side of the machine. 2. Remove three clips (2), then remove dust cup (3). 3. Remove outer element(4). NOTICE Never remove inner element (5). If it is removed, dust will enter and cause an engine trouble. NOTICE When cleaning the dust cup, do not remove evacuator valve(6). 4. Clean the inside of the air cleaner body and dust cup. NOTICE The inner element must not be cleaned and used again. When replacing the outer element, replace the inner ele- ment at the same time. 5.

Direct dry compressed air (less than 0.69 MPa (7 kg/cm 2 , 99.4 PSI)) to the outer element (3) from inside along its folds, then direct it from outside along its folds and again from inside 6. If small holes or thinner parts are found on the element when it is checked by shining a light through it after clean- ing, replace the element. NOTICE When cleaning the element, do not hit or beat it against anything. Do not use an element whose folds, gasket or seal are damaged. 7. Set the cleaned outer element and install dust cup(3), then secure them with clips(2). 4-19