SERVICE PROCEDURE MAINTENANCE When installing the dust cup, check O-ring(7). If the O-ring has any defect, replace it. 8. Press the dust indicator button to return the yellow piston to its original position. 9. Close the top cover at the front of the engine side cover on the right side of the machine. After cleaning, if the air cleaner clogging caution lamp lights up immediately or the yellow piston reaches the red line (7.5 kPa), replace the inner and outer elements. REPLACING ELEMENT 0. 1. 1. Open the top cover at the front of the engine side cover on the right side of the machine. 2. Remove three clips (2), then remove dust cup (3). 3. Remove outer element(4).
Do not remove inner element(5) at this time, however. NOTICE When cleaning the dust cup, do not remove evacuator valve(6). 4. Clean the inside of the air cleaner body and dust cup. 5. Remove inner element(5), then install a new inner element immediately. 6. Set new outer element(4) and install dust cup(3), then secure them with clips(2). When installing the dust cup, check O-ring(7). If the O-ring has any defect, replace it. 7. Press the dust indicator button to return the yellow piston to its original position. 8. Close the top cover at the front of the engine side cover on the right side of the machine. 4-20 CAUTION CAUTION