Komatsu — CHECK ENGINE ELECTROLYTE LEVEL

MAINTENANCE SERVICE PROCEDURE EVERY 250 HOURS SERVICE 0. Maintenance for every 50 and 100 hours service should be carried out at the same time. CHECK ENGINE ELECTROLYTE LEVEL 0. Carry out this check before operating the machine. Do not use the battery if the battery electrolyte level is below the LOWER LEVEL line. This will accel- erate deterioration of the inside of the battery and reduce the service life of the battery. In addition, it may also cause an explosion. The battery generates flammable gas and there is danger of explosion, so do not bring fire or sparks near the battery. Battery electrolyte is dangerous.

If it gets in your eyes or on your skin, wash it off with large amount of water and consult a doctor. When adding distilled water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If the electrolyte level is too high, it may leak and cause damage to the paint surface or corrode other parts. NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. Inspect the battery electrolyte level at least once a month and follow the basic safety procedures given below. WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE OF BATTERY 0.

If it is possible to check the electrolyte level from the side of the battery, check as follows. 1. Open the cover of the battery box. There are two battery boxes: One on each side at the rear of the machine. 2. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L) and LOWER LEVEL (L.L) lines. If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. 3. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 4.

If distilled water has been added to any cell of cap (1), add distilled water also to the other cells. 5. Clean the vents of the battery caps, then close the caps securely. Keep the top of the battery clean and wipe it with a wet cloth. REMARK If distilled water is added to above the U.L line, use a pipette to lower the level to the U.L line. Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker. 4-41 WARNING