Komatsu — CLEAN FUEL STRAINER

MAINTENANCE SERVICE PROCEDURE CLEAN FUEL STRAINER 0. After the engine is stopped, all parts are at high temperature, so do not replace the strainer immedi- ately. Wait for the parts to cool down before carrying out the replacement. The engine fuel piping line is under high pressure when the engine is running. When replacing the strainer, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before replacing the strainer. Never bring any flame close. This engine consists of higher precision parts than on the conventional fuel injection pump and noz- zle, so if dirt gets in, it will cause problems.

If there is any dirt stuck to the fuel line, use fuel to wash it off completely. Container to catch the oil Filter wrench 1. Set the container under the fuel strainer to catch the fuel. 2. Using the filter wrench, turn ring (1) to the left to loosen it, then remove element cup (2) and the element. 3. Wash the element and the inside of element cup (2) with clean fuel. 4. Clean the strainer head, fill the element cup with clean fuel, coat the packing surface thinly with engine oil, then install to the head, taking care not to damage the O-ring. Always use clean fuel when filling the element cup and be careful not to let any dirt or dust get in. 5.

When installing, turn ring (1) to the right to tighten it. Tightening torque: 23 to 27 NІm (2.3 to 2.7 kgfІm, 16.6 to 19.5 lbft) If the ring is loose, it will cause leakage of fuel, so always tighten it to the specified torque. 6. After installing element cup (2), bleed the air as follows. 7. Loosen air bleed plug (3) of the fuel filter. 8. Loosen the knob of priming pump (4), then pump it up and down until no more bubbles come out with the fuel from air bleed plug (3). 9. Tighten air bleed plug (2). Tightening torque: 7.8 to 9.8 NІm (0.8 to 1 kgfІm, 5.8 to 7.2 lbft) 10.Push in the knob of priming pump (4) and tighten it. 4-49 WARNING