SERVICE PROCEDURE MAINTENANCE EVERY 1000 HOURS SERVICE 0. Maintenance for every 50, 100, 250 and 500 hours service should be carried out at the same time. CHANGE OIL IN TRANSMISSION CASE AND TRANSMISSION OIL FILTER CAR- TRIDGE, CLEAN STRAINER 0. The parts and oil are at high temperature after the engine is stopped, and may cause burns.Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. Container to catch drained oil: Min 65 liters (17.17 US gal) capacity Refill capacity: 54 liters (14.27 US gal) Filter wrench 1.
Set a container to catch the oil under drain plug (P), then remove drain plug (P) and drain the oil. To prevent the oil from pouring out suddenly, loosen drain plug (P) and remove it gradually. 2. After draining the oil, install drain plug (P). Tightening torque: 68.6 ± 9.8 NІm (7.0 ± 1.0 kgfІm, 50.6 ± 7.2 lbft) 3. Set a container to catch the oil under the transmission filter. 4. Remove drain plug (1) of the transmission filter, drain the oil, then tighten the plug again. 5. Using a filter wrench, turn filter cartridge (2) to the left to remove it. 6. Clean in the filter holder, coat the seal surface and thread of the new filter cartridge with engine oil, then install it. 7.
When the seal surface comes into contact with the filter holder, tighten a further 2/5 turns with the filter wrench. 8. Remove 4 bolts (3), move tube (4), then remove strainer (5). 9. Remove any dirt stuck to strainer (5), then wash it in clean diesel fuel or flushing oil. If strainer (5) is damaged, replace it with a new part. 10.Install strainer (5) in the case. Replace the O-ring of tube (4) with a new part, then install tube (4). 4-50 WARNING