Komatsu — REPLACE CORROSION RESISTOR CARTRIDGE

MAINTENANCE SERVICE PROCEDURE 11.Pour in the specified amount of engine oil from oil filler (F). 12.After filling with oil, check that the oil is at the specified level. For details, see “CHECK TRANSMISSION OIL LEVEL, ADD OIL ( 4-24 )“. 13.Check that there is no leakage of oil from the transmission case or oil filter. CLEAN TRANSMISSION CASE BREATHER 0. 1. Open cover (1) on the cab side of the engine hood. 2. Remove the mud and dirt from around the breather, then remove breather (2), soak it in washing liquid and wash it. After removing the breather, take steps to prevent dirt or dust from entering the mount. CHECK TIGTENING PARTS OF TURBOCHARGER 0.

Please contact your Komatsu distributor to have the tightening portions checked. CHECK PLAY OF TURBOCHARGER ROTOR 0. Please contact your Komatsu distributor to have the rotor play checked. REPLACE CORROSION RESISTOR CARTRIDGE 0. 1. Set 2 levers (1) at the top of the corrosion resistor to the side to the CLOSED position. 2. Using a filter wrench, turn cartridge (2) to the left to remove it. 3. Apply engine oil to the sealing surface of a new cartridge, then install it to the filter holder. 4. Bring the packing surface into contact with the seal surface of the filter holder, then tighten a further approx. 2/3 turns. 5. Set 2 levers (1) vertically to the OPEN position. 4-51