Komatsu — GENERAL LOCATIONS AND FUNCTIONS OF CONTROL PANEL

ATTACHMENTS, OPTIONS AUTOMATIC AIR-CONDITIONER MODE SELECTOR SWITCH 0. This switch (4) is used to select the vents. The vent position can be selected from five modes: FACE, FACE/FOOT, FOOT, FOOT/DEF, DEF. When this switch (4) is pressed, the display on monitor panel (7) changes in turn, and the air blows out from the vents shown in the display. During automatic operation, the vents are automatically selected. AUTO SWITCH 0. With this switch (5), the air flow, vents, and air source (RECIRC/FRESH) are automatically selected according to the set temperature. This switch also acts as the air conditioner main switch.

When auto switch (5) is pressed, the lamp at the top of the auto switch lights up and the auto mode is displayed. When the fan switch is pressed, the lamp at the top of the auto switch goes out. Normally, press this switch, then use temperature control switch (3) to set the temperature, and run the air conditioner under automatic control. When the control is switched from automatic operation to manual operation, it is possible to operate the switch to change the air flow, vents, and air source (RECIRC/ FRESH). When the manual control is used, the lamp at the top of the auto switch goes out. RECIRC/FRESH SELECTOR SWITCH 0.

This switch (6) is used to switch the air source between recircu- lation of the air inside the cab and intake of air from the outside. When switch (6) is pressed, the lamp at the top of the selec- tor switch lights up to show that air is being blown out. During automatic operation, the selection of inside air (RECIRC) and outside air (FRESH) is carried out automati- cally. 6-37 RECIRC The outside air is shut off and only the air inside the cab is circulated Use this position to carry out rapid cooling of the cab or when the ou side air is dirty. FRESH Outside air is taken into the cab. Use this position to take in fresh air or when carrying out demisting.