Komatsu — PRECAUTIONS FOR MAINTENANCE

SAFETY PRECAUTIONS FOR MAINTENANCE WORK UNDER THE RAISED BOOM 0. Danger of injury! The raised boom may suddenly fall! For safety reasons, a raised boom must be secured against dropping before you pass or stand under it. The boom must be secured against moving if any work is to be carried out under it when it is in a raised position. For this purpose you should use a supporting prop (1) which is to be positioned below the boom. Park the machine on level, solid ground. Apply the parking brake. Place wheel chocks in front of the wheels to prevent the machine from inadvertently rolling away. Lift the arm far enough to allow the supporting prop to be placed beneath the boom.

Switch off the engine. With the engine switched off, lower the boom slowly until it rests on the supporting prop. Set the control lever to "NEUTRAL" and secure it with the safety lever (2) (locked). PRECAUTIONS WHEN USING HAMMER 0. When using a hammer, pins may fly out or metal particles may be scattered. This may lead to serious injury. Always do as follows. If hard metal parts such as pins, bucket teeth, cutting edges, or bearings are hit with a hammer, there is a hazard that pieces might be scattered and cause injury. Always wear safety goggles and gloves.

When hitting pins or bucket teeth, there is a hazard that bro- ken pieces might be sent flying and injure people in the sur- rounding area. Always check that there is no one in the surrounding area. If pins are hit with strong force, there is a hazard that the pin may fly out and injure people in the surrounding area. REPAIR WELDING 0. Welding operations must always be carried out by a qualified welder and in a place equipped with a proper equip- ment. There is a hazard of fire or electrocution when carrying out welding, so never allow any unqualified person- nel to carry out welding. 2-29 WARNING