PRECAUTIONS FOR MAINTENANCE SAFETY REMOVING BATTERY TERMINAL 0. When repairing the electrical system or when carrying out electrical welding, remove the negative (-) terminal of the battery to prevent the flow of current. PRECAUTIONS WITH HIGH-PRESSURE OIL 0. The hydraulic system is always under internal pressure. When inspecting or replacing piping or hoses, always check that the pressure in the hydraulic circuit has been released. If the circuit is still under pressure, it will lead to serious injury or property damage, so always do as follows. When carrying out inspection and maintenance of the pressure, release the pressure before starting.
For details, see “MAINTENANCE WITH ENGINE RUNNING ( 2-26 )“. Do not carry out inspection or replacement work with the circuit under pressure. If there is any leakage from the piping or hoses, the surrounding area will be wet, so check for cracks in the pip- ing and hoses and for swelling in the hoses. When carry out inspection, wear safety glasses and leather gloves. There is a hazard that high-pressure oil leaking from small holes may penetrate your skin or cause blindness if it con- tacts your eyes directly. If you are hit by a jet of high-pres- sure oil and suffer injury to your skin or eyes, wash the place with clean water, and consult a doctor immediately for medical attention.
The pressure in the E.C.S.S. circuit is stored by an accumu- lator. Do not remove the E.C.S.S. piping or components. If it is necessary to remove them, please ask your Komatsu distributor to carry out the removal operation. PRECAUTIONS FOR HIGH-PRESSURE FUEL 0. High pressure is generated inside the engine fuel piping when the engine is running. When carrying out inspection or maintenance of the fuel piping system, wait for at least 30 seconds after stopping the engine to let the internal pressure go down before starting inspection or maintenance. HANDLING HIGH-PRESSURE HOSES 0.
If oil or fuel leaks from high-pressure hoses, it may cause fire or defective operation, which may lead to serious injury or property damage. If any loose bolts are found, stop work and tighten to the specified torque. If any damaged hoses are found, stop operations immediately and contact your Komatsu distributor. Replace all hoses every 2 years at the latest. The shelf life of the hose should not exceed 2 years. Replace the hose if any of the following problems are found: Damaged or leaking hydraulic fitting. Frayed or cut covering or exposed reinforcement layer of wire. Covering swollen in places. Twisted or crushed movable portion. Foreign material embedded in covering.
When replacing the hoses, always replace the O-rings, gaskets, and other such parts at the same time. For details, see "PERIODIC REPLACEMENT OF SAFETY CRITICAL PARTS ( 4-14 )". PRECAUTIONS FOR HIGH VOLTAGE 0. When the engine is running and immediately after it is stopped, high voltage is generated inside the engine con- troller and the engine injector, and there is danger of elec- trocution. Never touch the inside of the controller or the engine injector portion. If it is necessary to touch the inside of the controller or the engine injector portion, please contact your Komatsu distrib- utor. 2-30