Komatsu — SWITCHES

OPERATION EXPLANATION OF COMPONENTS STARTING SWITCH 0. This switch(1) is used to start or stop the engine. OFF position It is possible to insert and remove the starting switch key, all the electric system switches are turned off, and the engine stops. In addition, the parking brake is automatically applied. ON position Electric current flows in the charging circuit, lamp circuit, and accessory circuit. Keep the starting switch key at the ON position while the engine is running. AE41474B-2 START position This is the position to start the engine. Hold the key at this position while cranking. Release the key immediately after the engine has been started.

The key will return to the ON position when released. HYDRAULIC MODE SELECTION SWITCH 0. This switch (2) can be used to give more power either to the drive or to the hydraulic system. LEFT position: STANDARD mode When the STANDARD mode is selected, full hydraulic power can be given to the work equipment. Use this switch position for normal operations. RIGHT position: HEAVY mode When the HEAVY mode is selected, fuel consumption will be reduced by decrease of the work equipment load and travel performance will be improved, especially uphill. Use this switch position for hopper feeding operations or fine control of heavy loads. TRANSMISSION SHIFT MODE SELECTOR SWITCH 0.

This switch (3) is used to change the shift point when the AUTO SHIFT/MANUAL selector switch has been switched to auto shift. At each of the L, M, and H positions, the system switches to auto shift and the auto shift pilot lamp on the machine monitor lights up. Normally, set to auto shift. MANUAL position: System is set to manual shift and speed range is position selected by gearshift lever L position: Travel speed when shifting up is low (flat ground, normal travel) M position: Travel speed when shifting up is medium (traveling uphill, traveling at high speed) H position:

Travel speed when shifting up is high (traveling uphill, traveling at high speed) REMARK For details of the manual shift, see “MANUAL SHIFT ( 3-52 )“. For details of the auto-shift, see “AUTOMATIC SHIFT ( 3-53 )“. 3-39