eng — CHECK, CLEAN OR REPLACE AIR CLEANER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE After cleaning, install again. 4 - 20 4. If sma ll holes o it is ch ecked by shining a light through it after cleaning, replace the el NOTICE When clea ning the el ement, do not hit or beat it Do n ot use an elemen t whose folds, gasket or s 5. Remo ve the cl oth or tape cover fitted i n Step 1. 6. Set th e cleaned element in position, an d secure it with the wing nut (2 ). 7. If any seal wash er (4) or wing nut (2) is damaged, replace it with a new part. 8. Remo ve vacua tor valve (5) and clean REPLACING INNER ELEMENT lement, and then remove the inner element. de) with a clean cloth or tape.

n remove the cover installed in Step 2. d tighten it with nuts. ment. with the wing nut. with compressed air. 1. 2. 3. 4. 5. 6. 7. 1. First r emove th e cover and the outer e lement, and then remove the inner 2. Cove r the air c onnector side (outlet si de) with a clean cloth or tape. 3. Clean the air cl eaner body interior, the n remove the cover installed in Step 4. Fit a new inner element to the body an Do no t clean a nd reinstall an inner ele 5. Instal l the oute r element and fasten it 6. Remo ve vacua tor valve (5) and clean After cleaning, install again. 7.

After replacing the element, return the red piston in the dust indicator to its original positio REMARK For both of inner element and outer element, when the element is attached, nuts should be tighten up with the For is attached, shaking m otion of e lement in the way that t he sealing rubber of the tip of the element closely co ntact with the inside of t he bod y.