eng — CHECK FAN BELT FOR WEAR AND REPLACE

. MAINTENANCE SERVICE PROCEDURE CHECK WEAR OF FRONT DISC BRAKE PADS WARNING for right CLEAN, CHECK RADIATOR FINS WARNING If compressed air scattered around dust and debris, there is danger of injury. Always wear protective equipment such as protective glasses and mask. is 4 - 57 If the pad is cotinued to use after the period of wear limit, not only the disk wi ll be damaged bu t also the brake will l oose its effect, and it is dangerous. I time.

f the period of wear limit approaches, c heck frequently the condition to change the pad a t proper Perform inspection every 25 0 hours if the work site is covered by lot s of earth a nd sand and if it is at the location where the foot brake is frequently used. Measure the thickness of p ad, and if the thickness is less, tha mm (0.12 in), please co replacement. ntact your Komatsu distributor The pad wear is not neces sarily the same for the left and r wheels, so always check th e pads on both the left and right. If of the pads has reached the wear limit, always replace all 4 pa If the work is performed on t he muddy and watery ground, the sticks to caliper or disc.

Lea ving the mud will increase the wea pad, so wash out thoroughl If the radiator fins become c logged or bent, this may cause ov erheating o f the engine, so always clean or ca rry out inspection and take the nec essary actions. ut by using jets of air, steam, or water, e nozzle contact the fin. a (10 kgf/cm2, 142 PSI) MPa (4 kgf/cm2, 56.8 PSI) air or steam, keep the nozzle at 90 , and if any cracks or brittle places are In addition, check also for loose hose Cleaning can be carried o ut by using jets of air, steam, or wa but be careful not to let th e nozzle contact the fin. a (10 kgf/cm2, 142 PSI) MPa (4 kgf/cm2, 56.8 PSI) air or steam, keep the nozzle at Air pressure : Max.

0.98 MP Steam pressure : Max. 0.39 When using compressed degrees to the radiator. Examine the rubber hose , and if any cracks or brittle places found, replace the hose. clamps. In addition, check also for loose h CHECK FAN BELT FOR Since inspection and replac ement of the fan belt requires spe cial tools, contact your Ko The machine is equipped w replaced. ith an auto-tensioner, so there is no need to carry out any adjustment until the For details of replacing the fan belt, see REPLACE FAN BEL T, ADJUS T AUTO TENSI ONER (PAGE 4-32