. MAINTENANCE SERVICE PROCEDURE EVERY 1000 HOURS SERVICE EVERY 250 HOURS MAINTENANCE, and EVERY 500 REPLACE CORROSION RESISTOR CARTRIDGE WARNING is no leakage of water from the filter seal 4 - 58 Carry out the EVE RY 100 HOURS MA INTENANC HOURS MAINTEN ANCE at the same tim All the engine parts a re at high temperature af ter the engin e has been operated, so never replace the cart ridge immediately after finishing operations. Wait for the oil to coo l down before replacing the cartridge Prepare a filter 1. Screw in valve (1) at the top of the co rrosion res 2. Set the contain er to catch the water under the c 3. Using a filter w rench, remove cartridg e (2). surface of nstall it. 4.
Clean the filter holder, coat the steel cartridge with c lean engine oil, then i 5. When installin g, tighten until the g asket cont seal surface of the f If the filter car damaged and t loose, water wil tighten the corr ilter holder, then tighte n a further 2/3 turns tridge is tightened to his will lead to leakage o far, the g of water. If asket wil the filter is l also leak from the gap at the gas ket, so always 6. Open valve (1) 7. After replacing that surface. If ther e is any leakage of wa ter, check t he tightening of