. ATTACHMENTS, OPTIONS HANDLING PAYLOAD METER 6 - 6 METHOD OF CARRYING OUT CALIBRATION the dump body empty. at the N position, and press calibration 1. 2. 3. 1. Set the machine with 2. Place the shift lever at the N position, and press calibration switch (1) for at least 2 seconds. (The letters CAL flash) 3. Drive the machine sl owly and when the travel spe ed reaches approx. 10 km/h (6.2 (The letters CAL lig MPH), press calibration switc ht up) The display returns t h (1) again. o the time display to show that t he calibration operation is co mpleted. Carry out calibration on a flat even road surface. ft)) . d are retained even when the power is turned off. Travel in a straight line.
( Distance: Approx. 100 m (328 Keep the machine traveli ng at a constant travel speed The calibration data are written to the internal RAM, an d are retained even when the power is turne To s top the calibration op eration (when in neutral), pre ss calibration switch (1) again . The dis play wi ll change fr a flashing CAL to a flashi ng SCH. When calibration swi tch (1) is pressed again, the d isplay w ill return to the nor display. CARRYING OUT SENSOR CHECK loaded on flat ground. 1. 2. 3. 1. Drive the machine un 2. Set the shift lever to "N" and press calibration switc h (1) for at least 2 seconds, the n press calibration switch (1) e letters SCH will flash) again for at least 2 seconds.
(Th When traveling at a s calibration switch (1) peed of approx. 10 km/h (6.2 M again. (The letters SCH will lig PH), press ht up) If the display returns to the time display, the sensor chec k operation is completed. If there is an abnormality in any sens or, the error code is displayed. Carry out the sensor check at least once every mo PRINTING OUT 1. 2. 1. When print out switch (1) is pressed for at least 2 se conds, the data are printed out. 2. When print feed switc h (2) is pressed for at least 2 s econds, the paper is fed. To stop the print du ring the printout, press the print switch Do not hold the pap er coming out from the printer printout. This will cau se the print to overlap.