. ATTACHMENTS, OPTIONS ARSC (AUTOMATIC RETARDER SPEED CONTROL) 6 - 31 METHOD OF DECREASING SET TRAVEL SPEED If it is desired to dec rease the set speed, operate the re tarder control lever to red uce speed, and w hen the desired set travel speed is r eached, press the set switch on the ARSC set lever. The set t ravel speed will be changed to the new speed. REMARK After using the retar der control lever to reduce the spe ed, return it to its original TRAVELING AGAIN AT SET TRAVEL SPEED If the machine repe atedly travels on the same slope, o nce the travel speed has been set, it is pos sible to operate the ARSC without c arrying out the setting operation ea ch time.
Before entering a do wnhill slope, if the travel speed has been adjusted to a speed l ower than the set s peed displayed on the travel speed display, the READY lamp (green) li ghts and the ARSC is act uated when the a ccelerator pedal is released. REMARK When traveling at a speed greater than the set speed displayed on the travel speed display, the ARSC is not not actuated even when the accelerator pedal is released. When this happens, the R EADY lamp (gree n) also does not light up. Always adj ust the travel speed to a speed low er than the set speed disp layed on the trave l speed display, and check that the READY lamp lights up. METHOD OF CANCELING SET TRAVEL SPEED Method 1:
If the can cel operation is carried out for more than 1 second, the contr ol is stopped. Whe n this happens, the set s peed display shows 0. tem switch is turned OFF, the control is canceled. When this happens, the set speed display Method 2: If the sys goes out. REMARK For Method 1, canc el operation must be continued for a t least 1 second (different from other switch es) to cancel the control. This is to pr event any problem of the control b eing canceled if the switc h is touched by mi stake.
RELATIONSHIP WITH EXHAUST BRAKE If the exhaust brake switch is at ON position (light is on ), the exhaust brake is act uated in the norm al way when the accelerator pedal is released if the torque converter loc k-up is ON (Lock-up pilot l amp lights up). Wh en the machine attempts to travel at a speed greater than the set spee d, the ARSC is also actu ated if the speed i s set in the way stated above. If the exhaust brake switch is at OFF position (light is off ), the exhaust brake is not actuated when th e ARSC is being operated. If the foot brake or retarder control lever are operated, the exhaust bra ke is actuated in t he same way as normal.
If the downhill slope is not steep and the engine brake and exhaust brake have ample effect, the machine will not accelerate to the se t travel speed, so the ARSC may n ot be actuated. RECOMMENDED SE T TRAVEL SPEED Set the travel speed so that the engine speed is at lea st 1,800 rpm, and travel s o that the retarder oil temperature gauge is in the gree n range. OVERHEAT WARNI NG at the retarder oil may overheat, the ARSC caution lamp lights up and the set travel speed is If there is danger th e ARSC caution lamp lig d is automatically reduc ed 1 km/h (0.6 MPH) every 3 secon ds. The lower value for th e set travel speed when the speed is automatically red uced is 10 km/h (6.2 MPH).