. ATTACHMENTS, OPTIONS HANDLING AUTO-GREASING SYSTEM SETTING GREASE CAN the grease pump. Follower plate part No. When using grease can 427-S95-2510 When not using grease can 427-S95-2520 REMARK Follower plate 427-S95-2510 is applicable for cans with an inside diameter from 275 mm to 290 mm. 3. Insert the pump tube at the top of the grease pump into the grease, then set follower plate (5) inside grease can (4). 4. Check that there is no leakage of grease from between grease can (4) and follower plate (5). 5. Secure with latches (2) at the top of grease pump (1). 6 - 46 NOTICE Check that ther e is no den t in the can.
If there i s a d ent, t he follower plate will not go down to the botto m and it will be impossible to carry out greasing. This brings the danger of damag e caused by i nsufficien t greasing of the machine. 1. Release 4 latches ( 2) of g rease pump (1) , and open the top o 2. Insert grease can ( 4) into case (3) of the grease pump. The applicabl e followe r plate differ s accordin g to whether the grease can is used or not. Use the appropriat e part No. follower p late