eng — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS OFF position (Light is off): If the ambient temperature is below approx. - 5 ° C (23 ° F), preheating is carried out automatically according to the ambient temperature. 3 - 26 NIGHT LIGHTING DIMMER SWITCH This s witch ( 7) is used to adjust the brightness of the monitor p anel lightin g and pilot lamps. Turn to the right to make the lighting bright er and turn it to the left to ma ke the lighting dimmer. AISS LOW SWITCH AUTO and L OW speed can be fre ely switched to each other with AISS LOW s witch (8). Use each p osition as follows. If the switch is depressed, it lights ht goes off.

up, and if it is depressed once osition al operation ed position nce again , the lig OFF position (Light is off): AUTO p At norm ON position (Light is on): Low spe When the needed garage delicate start and operatio n is like putting the machine into into If the switch is at AUTO position: 1. W s 2. D a 1. W hen st opping the machine, b y setting either parking brak e or retarder brake at ON position, idling is set at low peed. When starting, by settin g the parking brake at OFF position, idling is set at high spee d. 2. D etectin g the water temperatu re, idle is set at high speed automaticall y under the low temp erature condition nd the warm-up time is shorte ned.

PREHEATING SWITCH This s witch ( 9) operate an electric heater to heat the intake ai r for the e ngine. I f it is pushed, it lights up and perform preheating. If it is released, it returns to the origina l position. ON p osition (Light is on): Preheati Press this s witch if the engine doe s not start when only automatic preheating i s carried out or when p ost-heating is required after the engin e is sta rted. witch is released, it w eheating position. ill return automatically to the When the s automatic pr