eng — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS FRONT BRAKE CUT-OFF SWITCH WARNING and travel slowly at a safe speed. If the front brake cut-off switch is set to the OFF position, it becomes dangerously difficult to control the steering when traveling under the abovementioned conditions. 3 - 25 When traveling on i cy roads, on snow, or on other slippe ry road surfaces, set the front brake cut-off switch to the ON po sition This switch (5) switc hes the braking method accordi ng to the road surface conditions. sed, the lamp lights up, the front brake cut , and the brakes are not applied to the front sed again, the lamp goes out and the front canceled. If the switch is pres function is actuated wheels.

If the switch is pres brake cut function is OFF position (Light i s off.): When the brake ped al is depressed, the brakes are a pplied to both the front and rear w heels. on.): dal is depressed, the front brakes are not are applied only to the rear wheels. ON position (Light is When the brake pe applied. The brakes are applied only to the rear whe When traveling at hi gh speed, on a road surface tha t has been properly watered, set the fr ont brake cut-off s witch to OFF position (lam p off), and normally use the reta rder contro l lever t o control the travel speed (retarder br aking is applied only to the rear wheels).

To control the machi ne whenever emergency action is needed, such as when the machine slips to the side or when the machine has to b e stopped suddenly, use the bra ke pedal to operate the brakes on the fr ont wheels to give extra braking force. HAZARD LAMP SWITC H es the left- and right-hand turn signal lamps. This switch (6) flash es the left- and right-hand turn s ignal lamp When the switch is t urned on, the turn signal pilot la mp flashes at the same time. If th e starting switch is OFF, the turn signal pilot lamp does not flash.