Yanmar — 4.3.2 Reassembly

4. Disassembly and reassembly (15) Mounting the oil pan spacer and the oil pan Oil pan 1) Apply the liquid gasket to the surfaces of the gear case cover, gear case and flywheel housing that contact with the cylinder block. 2) Apply the liquid gasket to the spacer. Mount the spacer to the cylinder block and tighten the bolts. 3) Apply the liquid gasket to the oil pan. Mount the oil pan to the spacer and tighten the bolts. 4) Mount the dipstick and dipstick guide. Oil pan spacer 9 7 7 7 7 0 - 0 1 2 1 2 Cylinder block 9 7 7 7 7 0 - 0 1 2 1 2 Liquid gasket (16) Mounting the crankshaft pulley 1) Coat the oil seal with oil.

2) Make sure to wipe off oil on the taper surfaces of the crankshaft and the pulley. 3) Mount the pulley insertion tool to the crankshaft and install the pulley on the crankshaft so that the oil seal may not be damaged. 4) Tighten the pulley to the specified torque. Gear case cover Crankshaft pulley Oil seal Tightening torque N•m (kgf•m) Pulley insertion tool Crankshaft (17) Mounting the engine mounting feet and turning the engine upright. 1) Mount the engine mounting feet. 2) Turn the engine upright (Oil pan is the bottom side). (18) Mounting the flywheel 1) Coat the flywheel bolts threads with engine oil.

2) Align the positioning pins, and tighten the flywheel bolts to the specified torque. Tightening torque N•m (kgf•m) 95R1 V-pulley bolt (Material : casting iron) 83.3-93.3 (8.5-9.5) Flywheel bolt 80.4-86.4 (8.2-8.8)